NB: This article is for contractors that have already registered and purchased a seat to do inductions.

 
For instructions on how to register yourself or set up your staff for inductions / purchasing seats, please see here:

Register your staff for inductions (if you have a Cm3 account): https://cm3.elevio.help/en/articles/386-managing-your-staff-on-cm3-induct

Register yourself for inductions (If you don't have a Cm3 account): https://cm3.elevio.help/en/articles/385-registering-yourself-on-cm3-induct


1. Navigate to induct.cm3.com.au and log in to your Induction account using the details that you have set up:

2. Navigate to "My Inductions". You will find the "JLL Contractor Safety Induction" there, which is the general induction that is required before any site inductions can be completed.

NB: In order to access site inductions, all contractors must first have a completed "JLL Contractor safety induction".

3. Select the "JLL: Contractor Safety Induction.

4. In the "JLL: Contractor Safety Induction" you will find two areas that needs to be actioned. Each section is a separate movie that will need to be watched from start to finish. Each induction starts with an empty circle next to it to indicate that it has not been completed. When an induction is completed it will be marked with a checkmark.

5. The JLL Induction videos should start to play automatically, but if it does not, please press the "Play" button in the lower left corner to start the induction. Once the induction has reached its end, you will be able to complete the induction by selecting the button in the upper right corner.

NB: Please make sure you watch the inductions from start to finish without skipping ahead. The induction video can see which segments have been played and which have not. If any areas are marked as not viewed, you will not be able to complete the induction.

Once the induction has completed, make sure you select "Complete Video" found in the upper right corner. If you do not select this the induction will not be marked as completed.

6. Once both inductions are completed and you can confirm that both induction videos have checkmarks on the side, you can then confirm that this induction is "Complete". You may now start on your Site Inductions.

7. Navigate to "Site inductions". You can search for street addresses in the search bar and then select "Submit". 

NB: Please note that Cm3 uses shortenings of common road / street names. As such, 1 Elizabeth Street would be spelled 1 Elizabeth St. If your search returns no results, try searching with less words.

Once you have located your site induction, click the hyperlink associated with your site induction to access it.

8. Select the bottom option that says "launch course" to Access the site induction that you need to complete.

9. Site inductions are comprised of a number of PDF documents that needs to be read and agreed to. All unread documents starts with empty circles next to them to indicate that they have not yet been completed. Open all the documents in the induction and select "Yes I have read this document" to mark them as completed.

NB: If the induction document does not load inside the induction window, please select the link in the induction window to download the document.

10. Once all the documents are marked as read, you are done! You can navigate back to "My inductions" to confirm that the site induction is complete.


EXTRA: If you have not obtained a copy of your Certificate of Induction automatically, you can obtain a copy of this (Or send a copy to a person of your choice) by going to the "certificate" tab. 


Make sure that the "Send certificate to e-mail" is ticked, enter the e-mail address that you want to receive your certificate and finally select "Send Certificate"